Betekenis van:
point of reference

Voorbeeldzinnen

1. DETERMINATION OF SEAT REFERENCE POINT
2. An idle point is defined as a point having a normalised reference torque of 0 % and a normalised reference speed of 0 %.
3. Determination of the reference point (H point) of the seat in which the head restraint is incorporated
4. ‘Reference point’ means the position, fixed by convention, of the tractor driver's eyes notionally located at a single point.
5. Definition of a reference catenary remains an open point in the High Speed Energy TSI.
6. the last paragraph of point (e) (Reference period) shall be replaced by the following:
7. the reference authority may extend the period referred to in point (a) of paragraph 4.
8. The coordinates of the ‘H’ point are measured with respect to the three-dimensional reference system.
9. No load demand and reference torque < 0 per cent of maximum torque (motoring point)
10. Chapter 4.2.2 of the Guidelines is to be used as a point of reference for this examination.
11. However, no point on the apparent surface in the direction of the reference axis shall be higher than the highest point on the apparent surface in the direction of the reference axis of the dipped-beam headlamp.
12. For tractors of category T4.3, the operating space must, over the zone extending to 450 mm in front of the reference point, have at a height of 400 mm above the reference point, a total width of at least 700 mm, and at a height of 900 mm above the reference point, a total width of at least 600 mm.’
13. Only applicable to vehicles where the “Seating reference point (‘R’ point) ” of the lowest seat is not more than 700 mm high above the ground level.
14. The coordinates of the ‘R’ point and the ‘H’ point are established in relation to the fiducial marks defined by the vehicle manufacturer. Figure — Three-dimensional reference system
15. With reference to Article 3(2) point (f), the competent authority may authorise the sending of eggs: